Body Fat %

Body Fat Percentage Calculator

Body fat percentage calculator: type your height, neck and waist, plus hips for women, and it works out your body fat with the US Navy tape formula.

Without shoes. 5 ft 10 in = 70 in.
Just below the voice box.
Men: at the navel.
Optional fieldsweight, age, waist at the hip bone
For fat mass, lean mass and the BMI-based estimate.
For the BMI-based estimate.
For relative fat mass (RFM): tape level with the top of the hip bone, after a normal breath out.

Type your numbers above. Commas work as decimal points (72,5 = 72.5).

Math runs in your browser. Nothing is saved or sent.
Prefer

Last updated October 7, 2026

Learn

What this calculator does

It can also show two other estimates next to it, so you can see how much the methods agree.

How the Navy tape formula works

The formula comes from two 1984 reports by James Hodgdon and Marcie Beckett at the Naval Health Research Center. They weighed 602 Navy men and 214 Navy women under water, a standard lab test at the time. Then they looked for the tape readings that best predicted the result.

For men, the best fit used the waist at the navel minus the neck, plus height. For women, it used the waist at its narrowest point, plus the hips, minus the neck, plus height. All of it is in centimeters. The formula gives body density first. A second formula, from the scientist William Siri (1961), turns density into percent fat: 495 divided by density, minus 450.

Here is the math for a man who is 70 inches tall, with a 15.5 inch neck and a 35 inch waist:

  1. Turn inches into cm: height 70 in = 177.8 cm, neck 15.5 in = 39.37 cm, waist 35 in = 88.9 cm.
  2. Waist minus neck: 88.9 - 39.37 = 49.53 cm.
  3. Body density: 1.0324 - 0.19077 x log10(49.53) + 0.15456 x log10(177.8) = 1.05682.
  4. Siri: 495 / 1.05682 - 450 = 18.4% body fat.

The calculator above does the same steps. It turns inches into centimeters first, because the report's numbers only work in centimeters.

Sources: Hodgdon and Beckett, Naval Health Research Center report 84-11 (men), 1984, DOI 10.21236/ADA143890; report 84-29 (women), 1984, DOI 10.21236/ADA146456; Siri 1961, in Techniques for Measuring Body Composition, DOI 10.17226/21603.

How to measure for the Navy formula

You need a tape that does not stretch, and a mirror or a helper. These steps follow the way the 1984 reports measured.

  1. Height. Stand straight without shoes and measure to the nearest quarter inch.
  2. Neck. Wrap the tape just below the voice box (the bump at the front of the throat). Let it slope down a little toward the front.
  3. Waist, men. Measure around the belly at the level of the navel. Keep the tape level with the floor. Read it after a normal breath out.
  4. Waist, women. Measure at the narrowest point of the waist, about midway between the bottom of the breastbone and the navel. Read it after a normal breath out.
  5. Hips, women. Measure around the buttocks at the point where they stick out the most.

Keep the tape on the skin so it follows the body without pressing in. Take each reading twice. In the reports, if two readings at a site differed by more than 1 cm (about 0.4 inch), a third was taken, and the average of all the readings at that site was used.

Sources: Hodgdon and Beckett, Naval Health Research Center report 84-11 (men), 1984, DOI 10.21236/ADA143890; report 84-29 (women), 1984, DOI 10.21236/ADA146456.

How much a tape mistake changes the result

Small tape errors matter. We ran the formula again with one reading changed at a time, to see how far the answer moves.

Reading that is offMan: +0.5 inMan: +1 cmWoman: +0.5 inWoman: +1 cm
Waist+0.9+0.7+0.6+0.5
Neck-1.0-0.7-0.6-0.5
Hipsnot usednot used+0.6+0.5
Height-0.2-0.2-0.3-0.3

Start points: a man 70 in tall with a 15.5 in neck and a 35 in waist (18.4% body fat), and a woman 65 in tall with a 13 in neck, a 29 in waist and 39 in hips (28.3% body fat). Values are percentage points.

So a half inch slip at the waist or neck moves a man's result by about 1 point. Height matters much less. This is why the same person can get a different answer on a different day. It is also why the tool can show two other estimates next to the Navy one.

Repeat-measure test: waiting for a person. We plan to have one adult measure each Navy site 3 times on 3 different days, write down the spread, and show how much the body fat result moved. This needs a real person with a tape, so it is not done yet. Until then, the table above is computed, not measured.

Sources: Calculated here from the formulas in Hodgdon and Beckett, Naval Health Research Center report 84-11 (men), 1984, DOI 10.21236/ADA143890; report 84-29 (women), 1984, DOI 10.21236/ADA146456.

We checked our math against the Navy's own tables

The 1984 reports also print long tables of body fat for each tape reading and height. We read every table cell we could get from the scanned reports and compared it with our formula.

ReportTable cells readSame whole percentWithin 1 point
Men (report 84-11)1,6691,6651,669
Women (report 84-29)1,4601,0841,441

The men's tables match our math almost cell for cell. The women's tables run a little lower than the printed formula, by 0.2 points on average, and some of the differences may be OCR errors from reading the old scans. We use the formula as printed, since that is what the report says to use.

Sources: Hodgdon and Beckett, Naval Health Research Center report 84-11 (men), 1984, DOI 10.21236/ADA143890; report 84-29 (women), 1984, DOI 10.21236/ADA146456.

Three estimates side by side

One number can look more exact than it is. So the calculator shows three methods together.

  • US Navy formula. Neck, waist, height, and hips for women. This is the main result.
  • Relative fat mass (RFM). A simpler formula from 2018 that uses only height and waist: 64 minus 20 times height divided by waist, plus 12 for women. Its authors, Woolcott and Bergman, built it on US national survey data checked against DXA body scans. That survey measured the waist at the top of the hip bone, not at the navel, so the tool gives RFM its own optional waist box.
  • BMI-based estimate. A formula from height, weight, age and sex, built by Dympna Gallagher's team in 2000. It is the same formula our body fat percentage chart uses.

The tool then shows the spread, which is the gap between the highest and the lowest. A big spread is a hint to measure again. If you have skinfold calipers, the body fat caliper calculator gives a fourth view.

Sources: Hodgdon and Beckett, Naval Health Research Center report 84-11 (men), 1984, DOI 10.21236/ADA143890; report 84-29 (women), 1984, DOI 10.21236/ADA146456; Woolcott and Bergman, Scientific Reports 2018, DOI 10.1038/s41598-018-29362-1, PMID 30030479; Gallagher and others, American Journal of Clinical Nutrition 2000, DOI 10.1093/ajcn/72.3.694, PMID 10966886.

What the military uses now

The Navy tape formula is famous because the US military used it for years. Both services changed their rules recently.

RuleWhoWhat is measuredThe line
Army, from July 2026SoldiersWaist at the navel and heightWaist-to-height ratio under 0.55
Army one-site tape formula (June 2023 message, now replaced)SoldiersWeight and abdomen at the navelBody fat at or under 20 to 26% (men) or 30 to 36% (women), by age
Navy, 2026 guideSailorsHeight, waist at the navel, weightRatio 0.5499 or less; if not, body fat at or under 26% (men) or 36% (women) from a table

The Navy's June 2026 guide no longer uses the neck or hips. It checks the waist-to-height ratio first. Only if that is 0.55 or more does it look up body fat in a table of height minus waist and weight. The Army dropped the tape test in July 2026 and now uses the waist-to-height ratio alone. Our Army body fat calculator shows the new Army line and the former tape formula. The formula on this page is still the Navy's research formula. It is just no longer how sailors are scored.

Sources: US Navy Guide-4, Body Composition Assessment, June 2026; Army Public Affairs, army.mil, July 7, 2026; ALARACT 046/2023, Attachment 1, Table B-2; Hodgdon and Beckett, Naval Health Research Center report 84-11 (men), 1984, DOI 10.21236/ADA143890; report 84-29 (women), 1984, DOI 10.21236/ADA146456.

How accurate is the Navy method?

The reports give their own error sizes. For men, the typical error against under water weighing was 3.52 percentage points. For women it was 3.72 points. When other groups tested the formula on new people, the typical error was 2.70 points for 100 Navy men. For women it was 4.36 points in 66 Canadian Forces women and 4.04 points in 80 Navy women.

In plain words: if the tool says 20%, a lab test would often land a few points either way. That is fine for tracking your own trend with the same tape and the same method. It is not precise enough to split hairs between 19% and 21%.

Sources: Hodgdon and Beckett, Naval Health Research Center report 84-11 (men), 1984, DOI 10.21236/ADA143890; report 84-29 (women), 1984, DOI 10.21236/ADA146456.

What to do with the number

Body fat percent splits your weight into two parts. Fat mass is your weight times the percent. Lean mass is the rest: muscle, bone, organs and water. Add your weight to see both.

If you want to look at the lean side, the lean body mass calculator compares three formulas, and the FFMI calculator scales lean mass to height. The waist to height ratio calculator shows a simple waist check from the UK health guidance body, NICE.

Sources: NICE guideline NG246.

Questions

How do you calculate body fat percentage?

With the Navy method, you measure height, neck and waist, plus hips for women. The formula turns those into body density, and Siri's formula (495 divided by density, minus 450) turns density into percent fat. The calculator above does both steps for you.

Is the Navy body fat calculator accurate?

It is a fair estimate, not a lab test. In the 1984 Navy reports, the typical error against under water weighing was about 3.5 percentage points for men and 3.7 for women. Measuring the same way each time matters more than the exact number.

Can I calculate body fat with height and weight only?

Yes, but less well. The BMI-based estimate in the tool uses height, weight, age and sex. It is the Gallagher formula from 2000. It cannot tell muscle from fat, so it can be far off for very muscular people. A tape method adds real body shape.

How do I measure body fat at home?

The easiest home method is a soft tape: measure height, neck and waist, plus hips for women, and use the Navy formula. Skinfold calipers are another option, with their own calculator on this site.

Sources

9 sources
  1. Prediction of Percent Body Fat for U.S. Navy Men from Body Circumferences and Height, report 84-11, Hodgdon JA, Beckett MB, Naval Health Research Center, 1984, DTIC ADA143890, read 2026-10-06
  2. Prediction of Percent Body Fat for U.S. Navy Women from Body Circumferences and Height, report 84-29, Hodgdon JA, Beckett MB, Naval Health Research Center, 1984, DTIC ADA146456, read 2026-10-06
  3. Relative fat mass (RFM) as a new estimator of whole-body fat percentage, Woolcott OO, Bergman RN, Scientific Reports 2018, PMID 30030479, read 2026-10-06
  4. Healthy percentage body fat ranges: an approach for developing guidelines based on body mass index, Gallagher D et al., American Journal of Clinical Nutrition 2000, PMID 10966886 (abstract read 2026-10-06; equation as printed in Woolcott and Bergman 2018, Table 2)
  5. Body composition from fluid spaces and density: analysis of methods, Siri WE, in Techniques for Measuring Body Composition, National Academy of Sciences 1961 (formula as used in the Navy reports above)
  6. Guide-4, Body Composition Assessment (June 2026), US Navy Physical Readiness Program, read 2026-10-06
  7. Army modifies body composition program, adopts waist-to-height ratio, Army Public Affairs, July 7, 2026, read 2026-10-06
  8. ALARACT 046/2023, Notification of new Army body fat assessment, Headquarters, Department of the Army, June 12, 2023, Attachment 1: Table B-2 and Table B-5 (read from a saved copy 2026-10-05; the message says it expired June 9, 2024)
  9. NICE guideline NG246, read 2026-10-06